Widget HTML Atas

Home / Wire Light Bar To Rl44 Relay Diagram

Wire Light Bar To Rl44 Relay Diagram

Post a Comment

How to Conducting wire a Dome Light

by Bob White

itstillruns article image

transformable car interior image away St. Christopher Dodge from Fotolia.com

Navigating the interior of your vehicle at night derriere be a herculean task due to the low light. Installing a dome light will fix this a lot easier. Connecting the lighting to the vehicle's electric system will require some basic 12-volt knowledge, and you can control the light via the door switches or a change over mounted in the light fixture itself. With a fewer basic tools and whatsoever patience, you can complete this project ended a weekend.

Footstep 1

Feeling around the headliner with your hands for the standard dome light installation mounts. If your fomite doesn't have one or you can't settle information technology, choose an approximate localisation.

Step 2

Measure the width of the ceiling. Divide this telephone number in uncomplete and measure to the sum of the ceiling and mark this location with a pencil.

Step 3

Situate the interior fuse panel. If you are having difficulty the proprietor's manual will point you in the right direction. Hit the star's trim connected the side of the vehicle with the fuzee control panel.

Step 4

Cut a 1-column inch incision in the in store location of the dome light to feed the wire through. Turn the coat hanger into one straight slice. Tape the insulated wire to matchless end of it.

Step 5

Push the coat hanger past the door trim subordinate the headliner and in the direction of the dome light. Guild the hanger to the hole you have cut in the liner.

Step 6

Remove the wire from the end of the hanger and save the hole leaving enough duration to tighten to the wires comfortably. Remove the hanger.

Step 7

Install the reflector base to the noodle light localisation with the provided soul taping screws. Fasten the low-cal's ground wire under one of these screws. Be careful not to damage the roof's organic structure work. There should be a structural cross beam to saddle horse it to.

Step 8

Connect the light's overconfident wire to the insulated wire you fished past the headliner with a butt connecter. This connector workings by placing cardinal stripped wires in either end and compressing with pliers.

Step 9

Install a electric light in the socket and walkover the lens cover into its place.

Step 10

Run the wire from the side of the headliner to the fuse panel. Hide the telegram by pushing it into the edges of the interior trim work out.

Connect the wire to the fuse tap with a butt connector and get-up-and-go the tap into an available fuse location. Test the light for power.

References

Tips

  • You may receive to to the full remove the vehicle's headliner if you can't find an proper commit to mount the dome light.

Things You'll Need

  • Dome light with switch
  • Insulated electrical cable
  • Screw driver ordered
  • Butt connectors
  • Pair of pliers
  • Coat hanger
  • Measuring tape
  • Utility knife
  • Fuse tap with fuse

Writer Bio

Bob Empty began his authorship career in 2006. Working in sales, he was a technical author tasked with responding to requests for marriage offer. Albescent has a Artium Baccalaurens in computing and a diploma in home review. Atomic number 2 has besides worked in construction, landscaping and the pool industriousness for to a higher degree 15 geezerhood.

More Articles

Source: https://itstillruns.com/wire-dome-light-7914695.html

Posted by: blueskytop.blogspot.com